Table of Contents
Advertisement
Section 4: Installation
May 2022
Section 4: Installation
To assemble the OM9 into the EPI2 actuator, proceed as follows:
•
•
•
•
Figure 7
•
Figure 8
Follow one of the following assembling procedures depending on actuator model.
6
Ensure that all the parts received with the OM9 are available as described in
paragraph optional kits.
Using paragraph optional kits, select only mechanical parts (screws and spacers)
depending on actuator models.
Gather the right tools for the assembly and for setting the actuator controls.
With an Allen wrench of 5 mm, unscrew the cover screws, see Figure 7.
Remove the actuator cover, see Figure 8.
Installation, Operation and Maintenance Manual
VCIOM-01493-EN Rev. 0
Installation
Advertisement
Table of Contents
