Emerson IEC 62591 Instruction Manual page 48

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)
3-30
:
Notes
▪ You can also double-click a commissioned device on the
Commission screen to immediately access the Transmitter screen for
that device.
▪ If you use ROCLINK to change transmitter values when the
transmitter is busy with other communications tasks, the transmitter
may fail to update and reverts to previous values. If this occurs, you
can use ROCLINK to re-attempt the update when the transmitter is
not busy with other communications tasks. Alternately, avoid this
issue entirely by using a 475 Field Communicator to change
transmitter values.
Field
Transmitter
Tag
Message
Descriptor
Configuration Change
Counter
Transmitter
Information
Comm Status This read-only field shows the status of the
Device Status This read-only field shows the Field Device Status
Configuration and Commissioning
Description
Displays the 40-character alphanumeric tag
associated with the transmitter. The system adds
the logical position (here, 1 - ) to the tag. Click  to
display all devices currently defined for this
network.
Defines a 40-character alphanumeric identifier for
the transmitter (such as Tank2Level or
Pump1Temporary).
Provides an optional 40-character alphanumeric
message associated with the transmitter. Use this
field for explanatory or warning messages (such as
Not to exceed 300 psi).
Provides an optional 20-character alphanumeric
description of transmitter (such as Casing press).
This read-only field shows the number of times the
configuration of the transmitter has been changed,
as reported by the transmitter itself.
This section displays read-only information
reported by the transmitter, including serial
number, manufacturer ID, type of device, battery
life, and other data.
Note: Battery life is calculated by the transmitter.
Refer to the transmitter's manufacturer for
further details.
communications channel.
code to indicate the current communication and
operating state of the transmitter. For any value
other than 0, the field turns red.
Note: Hover your mouse over this field to view the
meaning of the response code. Response
codes are manufacturer-defined. Refer to
the documentation provided with the
transmitter or to the manufacturer's website
for a complete list of response codes, their
meanings, and their resolutions.
Revised June-2018