Emerson IEC 62591 Instruction Manual page 46

Wireless interface. for roc800-series and floboss 107
Hide thumbs Also See for IEC 62591:
Table of Contents

Advertisement

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)
Decommissioning a Device
Replacing a Device
3-28
Figure 3-16. Commissioned Device
Another indicator that the device has been successfully commissioned is
the activation of the Transmitter tab.
: If you change the tag for a transmitter using either a hand-held
Note
375/475 device or AMS, the new tag may not display until the
device appears on the Commissioned list.
If you decide to remove a device from your network, use this screen to
decommission the device. Select the device and drag it to the
Uncommissioned list.
: Remember to adjust or redefine any TLPs you have designated
Note
to accumulate the information for the decommissioned device's
logical position.
If a particular wireless device in your network stops working, you can
easily replace it with a similar device.
: Using this option does not require you to adjust or redefine any
Note
TLPs you have designated to accumulate the information for the
decommissioned device's logical position. The new device
assumes all parameters you have defined for the old device.
First, configure the device for the network, assigning it the appropriate
Network ID and Join Key. Install the device in the field. Start
ROCLINK 800, select the IEC 62591 module, and display the
Commission tab. When the replacement device appears on the
Uncommissioned list, select it and drag it on top of the non-working
Configuration and Commissioning
Revised June-2018

Advertisement

Table of Contents
loading

Table of Contents