Rebooting After A Power Loss; Usb Flash Drive Not Recognized; Errors From The Iec 62591 Transmitter Tab; Nan Value - Emerson IEC 62591 Instruction Manual

Wireless interface. for roc800-series and floboss 107

Hide thumbs Also See for IEC 62591:

Table of Contents

IEC62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)

4.2.4 Rebooting after a Power Loss

Revised June-2018

▪ Did you place the IEC62591 module in the proper slot as specified in the

IEC 62591 application?

▪ Did you assign a unique Long Tag Name to each wireless device and

specify the exact same long tag names in the IEC 62591 application?

▪ Did you assign a Network ID which must be the same in each and every

wireless device in this network, and must also match the Network ID

defined in the IEC 62591 application?

▪ Did you assign a Join Key which must be the same in each and every

wireless device in this network, and must also match the Join Key defined

in the IEC 62591 application?

In the event of low power or complete power loss, if the IEC module fails to

successfully reboot, the FB107 and/or ROC800 raise Communication Failure

and Point Failure alarms, indicating that IEC 62591 communications are not

functioning. To resolve the issue, remove and re-apply power to the RTU.

Module initialization can take up to five minutes. During this time, the USB

port on the module is not recognized. The module is initialized when the Status

field on the Network tab includes the word Online. If a USB flash drive is not

recognized after module initialization, power cycle your device and try again.

You can use the Transmitter Tab in ROCLINK 800 to check if there are

errors in configuration:

The Transmitter tab shows a NaN (Not a Number) warning when the

given parameter is currently in a failing state. To further investigate and

resolve the issue, use Field Tools, the AMS Device Configurator, or a

475 hand-held.

Troubleshooting

4-3

Table of Contents