Viewing Network Statistics - Emerson IEC 62591 Instruction Manual

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)

3.3.4 Viewing Network Statistics

Revised June-2018
Field
Publish Time Sets the time interval (in seconds) at which the
Max Publish Time Sets the maximum amount of time (in seconds)
Debounce Interval This read-only field shows the amount of time (in
Cur Event Time This read-only field shows the time of the current
Event Summary This read-only field shows any unacknowledged
Control Code This read-only field shows the Event Notification
Events Pending This read-only field displays a list of events on the
Reset Events Select this button to acknowledge all pending events
Click Apply to save any changes you may make to the values on this
screen.
: You can also double-click a commissioned device on the
Note
Commission screen to immediately access the Transmitter
screen for that device.
The network accumulates a variety of statistical information you can
review to assess system health. This content is returned from the
Configuration and Commissioning
Description
HART device publishes its events.
Note: This value must be less than or equal to the
value you set in the Maximum Update Time
field.
without publishing its events before the HART
device is forced to publish its events.
Note: This field applies only if you select
Windowed, Raising, Falling, or On-Change
in the Trigger Mode field.
seconds) that an event must persist before the
HART device sends a notification.
event as returned from the HART device (the
number of seconds that have passed since the start
of the day) and the system's interpretation of that
value.
pending events.
Control Code returned from the HART device.
Possible values are:
▪ Off
▪ Token Pass DLL
▪ TDMA DLL
▪ Both TDMA and Token DLLs
HART device that have not been acknowledged.
Possible values are:
▪ Configuration Changed Event
▪ Device Status Event
▪ More Status Available Event
on the HART device.
3-35