Emerson IEC 62591 Instruction Manual page 27

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)
Decommissioning a Device
Revised June-2018
▪ The device does not disappear from the Uncommissioned List until
communication issues have been resolved.
The number of rows on the Commission screen correlates to the number
of wireless devices your controller supports. Each row represents a
specific logical position. If, during commissioning, you want the
controller to store information from a specific wireless device in a
specific logical position, you can commission that device to that logical
by selecting that device and "dragging" it to the appropriate position on
the Commissioned list.
: Once you commission a device to a particular logical, you
Note
cannot drag it another logical position. You must first
decommission the device and then re-commission it to the new
logical position.
After a few minutes, the device moves from the Uncommissioned to the
Commissioned list:
Figure 3-6. Commissioned Device
Another indicator that the device has been successfully commissioned is
the activation of the Transmitter tab.
: If you change the tag for a transmitter using either a hand-held
Note
375/475 device or AMS, the new tag may not display until the
device appears on the Commissioned list.
If you decide to remove a device from your network, use this screen to
decommission the device. Select the device and drag it to the
Uncommissioned list.
Configuration and Commissioning 3-9