Table of Contents
Advertisement
User's Manual
3
Software installation and device setup
Topics covered in this chapter:
•
System requirements
•
Install the USB Fieldbus Interface Configuration utility
•
Install the Communication DTM software
•
Install the Emerson DTM Library
•
Setup and connection
•
Connect to a live fieldbus segment
Perform software installation and device setup in the following order:
1. Install the USB Fieldbus Interface Configuration utility.
This allows you to configure the USB Fieldbus Interface and connected
fieldbus devices.
2. Install the Communication DTM software.
This enables DTM support for connected fieldbus devices.
3. Install the Emerson DTM Library.
This allows you to use DTMs associated with Emerson devices through an
FDT Frame Application.
Note
Device DTMs are usually acquired from device suppliers. Contact your
device supplier if you have a non-Emerson device and install the
appropriate third-party DTM library.
4. Set up and configure connected fieldbus devices.
3.1
System requirements
Supported operating systems
Windows 7 (32- or 64-bit)
Windows 10
Hard disk space
500MB or more
Hardware
10
January 2019
Advertisement
Table of Contents
Need help?
Do you have a question about the USB Fieldbus Interface and is the answer not in the manual?
Questions and answers