Emerson Wireless 781 Field Link - Emerson IEC 62591 Instruction Manual

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)
USB Port
Caution
1.2.2
Revised June-2018
Figure 1-2. IEC 62591 Wireless Interface Module
You can place the module in any available slot on the ROC800 and in
any available slot on the FB107. However, each ROC800 or FB107 can
support only one IEC 62591 Wireless Interface module.
: For information on installing modules in the FB107, refer to the
Note
™
FloBoss
D301232X012). For information on installing modules in the
ROC800, refer to the ROC800-Series Remote Operations
Controller Instruction Manual (Part D301217X012).
The module's USB port supports firmware upgrades and provides
debug information for product support. For further information, refer
to Chapter 3, Configuration and Commissioning.
Do not use the USB connector unless the area is known to be non-
hazardous.

Emerson Wireless 781 Field Link

The second component in the Wireless Interface is the Field Link (see
Figure 1-3). You install the field link away from controller in the
optimal location for best network performance. A 4-wire connection
between the module and Field Link provides the 24 Vdc power the field
link requires and transmits communication signals sent to the field link
from the various WirelessHART field devices.
107 Flow Manager Instruction Manual (Part
General Information 1-3