Smart7-I And Smart7-W Manual Set Up For Wi-Fi Connection Between Master And Rover Via Icom1 - Novatel SMART7 Installation And Operation Manual

SMART7-I and SMART7-W Wi-Fi Configuration Overview
If interface_mode is omitted, it is assumed that the ALIGN MASTER Access Point is
already configured to transmit the desired corrections over the specified ICOM port.
Note that up to four rovers can be associated to the same Master, each using a different ICOM
port.
Example:
Enable Wi-Fi ALIGN corrections using receiver SM7-NMND17190003B as the Master.
Using a serial port connected to the Client, enter the following commands:
WIFINETCONFIG 1 ENABLE SM7-NMND17190003B SM7_PWD
WIFIALIGNAUTOMATION ENABLE 1 ICOM5 20 ON NOVATELX
SAVECONFIG
Internally, the SMART7 client does the following:
switches to Concurrent mode if currently configured as an Access Point or Client
l
scans for available Access Points until SM7-NMND17190003B is detected
l
connects to the SM7-NMND17190003B Access Point
l
configures itself as follows:
l
ICOMCONFIG ICOM5 TCP 192.168.19.1:3005
INTERFACEMODE ICOM5 NOVATEL NOVATEL ON
sends the following commands over ICOM5 to the Master:
l
UNLOGALL ICOM5 TRUE
MOVINGBASESTATION ENABLE
LOG ICOM5 NOVATELXOBS ONTIME .05
LOG ICOM5 NOVATELXREF ONTIME .05
INTERFACEMODE ICOM5 NOVATEL NOVATELX
configures itself as follows:
l
INTERFACEMODE ICOM5 NOVATELX NOVATEL OFF
LOG ICOM5 HEADINGEXTB ONNEW
5.6.2 SMART7-I and SMART7-W Manual Set Up for Wi-Fi Connection
between Master and Rover via ICOM1
In this setup, the ALIGN Rover acts as a Wi-Fi Client to the ALIGN Master which, by default, is
configured as a Wi-Fi Access Point.
Configure ALIGN Master
By default, the Master provides an Access Point with IP address of 192.168.19.1. No special con-
figuration is required to enable this functionality. The only configuration required at the Master
is to enable ALIGN corrections on ICOM1 as shown below:
SMART7 Installation and Operation User Manual 0C 88