Smart7 Operation; Communications With The Receiver; Serial Port Communications - Novatel SMART7 Installation And Operation Manual

SMART7 Operation

Before operating the receiver for the first time, refer to SMART7 Installation Overview on
page 21 for SMART7 installation instructions.
Refer to Communications with the Receiver below to begin configuring the SMART7 for oper-
ation.

3.1 Communications with the Receiver

Communication is established with the receiver using a data terminal or computer connected to
the receiver by a variety of methods:
SMART7-I and SMART7-W Wi-Fi Configuration Overview on page 81
l
Serial Port Communications below
l
Ethernet Communications on page 32
l
ICOM Communications on page 32
l
CAN Bus Communications on page 33
l
When connected to the receiver, enter commands directly from a terminal or through terminal
emulation software on a computer. For example:
NovAtel Web User Interface - The NovAtel Web User Interface is installed on OEM7
l
receivers. Refer to the online OEM7 documentation (docs.novatel.com/OEM7) for instruc-
tions.
NovAtel Connect - NovAtel Connect is a software application used to monitor and configure
l
NovAtel receivers. For information about installing and using NovAtel Connect, refer to the
help file included with the application.
NovAtel Connect version 2.0 or greater is required for OEM7 receivers.
Download the latest NovAtel Connect software and documentation from
www.novatel.com/novatel-connect.
Any console/command line application
l
To maximize the application of the receiver's capabilities, become familiar with the commands
and logs described in

3.1.1 Serial Port Communications

The receiver can communicate with a computer or terminal via a serial port. For communication
to occur, both the receiver and the operator interface have to be configured properly. The
receiver's default port settings are:
9600 bps
l
no parity
l
8 data bits
l
1 stop bit
l
SMART7 Installation and Operation User Manual 0C
Agriculture Commands and Logs Reference Manual.
30