Rover Station Configuration; External Align Master Or Rover Configuration Only - Novatel ProPak6 User Manual

Operation
3.4.3

Rover Station Configuration

At the rover station, enter the following commands:
interfacemode port rx_type tx_type [responses]
For example, if COM2 was connected to the correction source:
RTK Automated Correction Detection
interfacemode com2 auto none off
RTCA
interfacemode com2 rtca none off
RTCAOBS2
interfacemode com2 rtca none off
RTCM V2.3
interfacemode com2 rtcm none off
RTCM V3
interfacemode com2 rtcmv3 none off
RTCM V3 with GLONASS
interfacemode com2 rtcmv3 none off
CMR+
interfacemode com2 cmr none off
CMR
interfacemode com2 cmr none off
NOVATELX
interfacemode com2 NOVATELX none off
3.5

External ALIGN Master or Rover Configuration Only

 The ProPak6 product is a dual card enclosure that can provide an ALIGN solution
without additional receivers.
This section is for applications that require additional rover receivers.
This section provides instructions for setting up an external master station with additional ALIGN capable
rover receivers for applications requiring heading output. Refer to
at www.novatel.com/support/search/.
Automatic Set Up for Direct-Wire Connection between Master and Rover via COM2
alignautomation enable
or
alignautomation enable com2 230400 10 on
ProPak6 Installation and Operation User Manual Rev 4
(same as CMR+)
APN-048 ALIGN Overview and
Chapter 3
Setup,
49