Chapter 2 SMART7 Installation Overview
Figure 8: SMART7 and SMART6 Mounting Hole Locations
2.3 Connect the SMART7 to Data Communication Equipment
The SMART7 can communicate with other devices in the system, such as computers Wi-Fi or Eth-
ernet ports. The SMART7 also has a CAN bus port for communication with other CAN bus com-
patible devices.
Wi-Fi and Ethernet are model dependent.
2.3.1 Serial Ports
The SMART7 has three serial ports: COM1, COM2 and COM3. These ports are available on the
HD26 COM PORTS connector. Refer to Connect I/O Signals to the SMART7 on page 26 for the pin
out of this connector.
Use the SERIALCONFIG command to configure the receiver's asynchronous serial port com-
munications drivers.
SMART7 Installation and Operation User Manual 0C
Table 7:
SMART7 Serial
Port Protocol
Port
RS-232
COM1
Yes
COM2
Yes
COM3
Yes
24