Chapter 2 SMART7 Installation Overview
When the appropriate equipment is selected, complete the following steps to set up and begin
using the NovAtel GNSS receiver.
1. Mount the SMART7 receiver. Refer to Mounting and Orienting the SMART7 on the next page
for mounting details.
2. Connect other GNSS system components using the output lines.
See SMART7 Interface Cable (Optional Accessory) on page 136.
3. Connect the receiver to other GNSS system components, such as a computer or data ter-
minal, using the communication ports or Wi-Fi.
See Connect the SMART7 to Data Communication Equipment on page 24.
4. Connect the supplied interface cable to the interface connector on the receiver and then con-
nect the power cable to the power supply.
Ensure a 5 A slow blow fuse is incorporated in the power wiring. Refer to SMART7 Interface
Cable (Optional Accessory) on page 136 and SMART7 Additional Equipment Required on
SMART7 Installation and Operation User Manual 0C
Figure 5: SMART7 Installation
21