Examining The Rxstatus Log - Novatel SMART7 Installation And Operation Manual

Chapter 8 Troubleshooting
Symptom
A command is not accepted by the
receiver
Differential mode is not working
properly
There appears to be a problem with
the receiver's memory
An environmental or memory
failure. The receiver temperature is
out of acceptable range or the
internal thermometer is not
working
Overload and overrun problems.
Either the CPU or port buffers are
overloaded
The receiver is indicating that an
invalid authorization code has been
used
The receiver is being affected by
jamming
The receiver is being affected by
interference
The receiver's Automatic Gain
Control (AGC) is not working
properly

8.1 Examining the RXSTATUS Log

The RXSTATUS log provides detailed status information about your receiver and can be used to
diagnose problems. Refer to the in the
details on this log and on how to read the receiver error word and status word. Table 17: Resolv-
ing a Receiver Error Word on the next page, Table 18: Resolving an Error in the Receiver Status
Word on page 109 and Table 19: Resolving an Error in the AUX1 Status Word on page 110 have
SMART7 Installation and Operation User Manual 0C
Check for correct spelling and command syntax.
See Communications with the Receiver on page 30 and refer
to the FRESET command in the
Logs Reference Manual
See Transmitting and Receiving Corrections on page 34 and
refer to the SERIALCONFIG command in the
Commands and Logs Reference Manual
Refer to the NVMRESTORE command in the
Commands and Logs Reference Manual
Move the receiver to within an acceptable temperature
range. See:
SMART7 Environmental and Electrical Specifications on
l
page 133
Reduce the amount of logging or increase the baud rate.
Refer to the VERSION log or VALIDMODELS log and the
MODEL command or AUTH command in the
Commands and Logs Reference Manual
Move the receiver away from any possible jamming sources
Go to the Interference Toolkit section in the NovAtel
Documentation portal: docs.novatel.com/OEM7.
Move the GNSS antenna away from the source of the
interference signal.
If the interference mitigation feature is enabled on the
receiver, configure a filter within the Interference Toolkit to
filter out the interference signal.
See the jamming symptom in this table
Agriculture Commands and Logs Reference
Related Section
Agriculture Commands and
Agriculture
Agriculture
Agriculture
Manualfor
107