Status Code Arrays; Receiver Status Code; Auxiliary Status Codes; Figure 30: Status Code Arrays - Novatel SMART7 Installation And Operation Manual

Chapter 5 Built-In Status Tests
Refer to the RXSTATUS log and RXSTATUSEVENT log in the
Reference Manual
error, refer to Examining the RXSTATUS Log on page 107.

5.2.3 Status Code Arrays

There are currently 5 status code arrays:
receiver status word
l
auxiliary 1 status
l
auxiliary 2 status
l
auxiliary 3 status
l
auxiliary 4 status
l
Each status code array consists of four 32-bit words (the status word, a priority mask, a set
mask and a clear mask). The status word is similar to the error word, with each of the 32 bits
indicating a condition. The priority mask words are used to modify the behavior caused by a
change in one of the bits in the associated status words. Each bit, in any mask, operates on the
bit in the same position in the status word. For example, setting bit 3 in the priority mask
changes the priority of bit 3 in the status word.

5.2.4 Receiver Status Code

The receiver status word is included in the header of all logs. It has 32 bits that indicate certain
receiver conditions. If any of these conditions occur, a bit in the status word is set. Unlike the
error word bits, the receiver continues to operate, unless the priority mask for the bit has been
set. The priority mask bit changes the bit in the receiver status word into an error bit. Anything
that results from an error bit becoming active also occurs if a receiver status and its associated
priority mask bits are set.

5.2.5 Auxiliary Status Codes

The auxiliary status codes are only in the RXSTATUS log. The four arrays that represent the aux-
iliary status codes indicate the receiver state for information purposes only. The events rep-
resented by these bits typically do not cause receiver performance degradation. The priority
mask for the auxiliary codes does not put the receiver into an error state. Setting a bit in the aux-
iliary priority mask results in the corresponding bit in the receiver status code to be set if any
masked auxiliary bit is set. Bit 31 of the receiver status word indicates the condition of all
SMART7 Installation and Operation User Manual 0C
for more detailed log descriptions. If the receiver error word indicates an

Figure 30: Status Code Arrays

Agriculture Commands and Logs
79