Honda Civic 1998 Service Manual page 338

Before connecting a new {uel tube/quick-connect fitting
assembly, remove the old retainer from the mating pipe.
W i t h t h e
t a b s p u l l e d
apan, romove
and discard the
retainer
New FUEL IUBE/
OUICK4ONNECT
FTTTING ASSEMALY
3.
Align the quick-connect fittings with the pipe, and
align the retainer locking pawls with the connector
grooves. Then press the quick-connect fittings onto
the pipe until both retainer pawls lock with a click-
i n g s o u n d .
NOTE: lf it is hard to connect, put a small amount
of new engine oil on the pipe end.
Connection with new reiainer:
I
4.
Make sure the connection is secure and the pawls
are firmly locked into place; check visually and by
pulling the connector.
RETAIiIER
Reconnect the baftery negative cable. and turn the
i g n i t i o n s w i t c h O N ( l l ) . T h e f u e l p u m p w i l l r u n f o r
a b o u t t w o s e c o n d s . a n d f u e l p r e s s u r e w i l l r i s e .
Repeat two or three times, and check that there is
no leakage in the tuel supply systen..
11 -1 49