To Make Measurements Without Interrupting Your Dut - Keysight N2820A User Manual

To Make Measurements Without Interrupting Your DUT

N2820/1A User's Guide
To Make Measurements Without Interrupting Your DUT
The supplied Make-Before-Break (MBB) connectors allow you to
easily connect and disconnect your probe without interrupting the
Device-Under-Test (DUT). With the MBB connector you can
quickly probe multiple locations on your DUT without having to
solder or unsolder the leads. The MBB can be used with all R
probe heads including the N2825A user-defined probe head.
Figure 16 Probing with MBB Connector on DUT
As shown in Figure 17
receptacle and header. A sensor lead with socket snaps onto the
receptacle. The header has two 0.025" square pins that are
soldered onto pads with 2.54 mm (0.1") contact-pitch spacing.
Making Measurements
on page 40, MBB connectors consist of a
2
SENSE
39