Quick Start - Keysight N2820A User Manual

Quick Start

Attach the Sensor Leads
N2820/1A User's Guide
Step 1.
The probe heads do not come with the leads soldered on them.
Instead, you must solder on one of the following types of sensor
leads to the probe head.
• Accessory un-socketed leads (22 AWG).
• Accessory socketed leads (22 AWG).
• Your own leads.
The socketed leads are designed to plug directly onto the following
items:
• Standard PC board headers with 2.54 mm (0.1") contact-pitch
spacing.
• MBB accessory headers mounted on the PC board. You can
quickly snap the socketed lead on and off the MBB header. To
learn about the MBB accessory, refer to
Measurements Without Interrupting Your DUT"
1 Position the sensor leads into the head's access hole as shown in
Figure 4.
Figure 4
2 Flip the head as shown in
the PC board's solder holes TP1 and TP2. Insert the
TP2 and the BLACK lead at TP1. Solder the leads in place.
Placing the Leads into the Tip's Access Hole
Figure 5
Making Measurements
Quick Start
"To Make
on page 39.
and insert the leads up through
RED
2
(+) lead at
23