Keysight N2820A User Manual page 29

Configuring the Probe on
InfiniiVision Oscilloscopes
N2820/1A User's Guide
Step 6.
1 Press the front-panel channel key that is associated with the probe.
In the case of N2820A probes, the probe's primary channel.
2 Press the Probe softkey.
3 If you are using an N2821A probe, press the Zoom-In softkey to
toggle between zoomed-in (blue selection box on softkey) or
zoomed-out (clear selection box) for the channel. This softkey is
shown at the bottom of
4 If you are using an N2825A user-defined head, which uses a
DUT-mounted R
Figure 10
resistor that you are using.
The above step manually enters the N2825A's associated external R
NOTE
resistance. But, when using multiple R
will find more convenient procedures in
Heads".
For N2820A probes, softkeys for the probe's primary channel configure
NOTE
both the primary and secondary channel. Unlike Infiniium oscilloscopes,
InfiniiVision oscilloscopes do not support the assigning of names to
identify N2825A/R
Figure 10
resistor, press the R-Sense softkey, shown in
SENSE
on page 30. Then, enter the resistance of the R
combinations.
SENSE
Making Measurements
Quick Start
on page 30.
resistors on your DUTs, you
SENSE
Chapter 3, "Using N2825A Probe
2
SENSE
SENSE
29