Keysight N2820A User Manual page 25

CAUTION
Attach the Secondary
N2820/1A User's Guide
Do not remove the four head screws when removing the head.
NOTE
You can safely change a probe head while the probe is connected to an
NOTE
oscilloscope that is powered on.
If lead wires are attached, do not pull on the wires as this could damage
the head.
Step 3.
This step is for N2820A two-channel probes only. N2821A probes
are not designed for use with the secondary cable and cannot be
Cable
upgraded.
• Gently snap the secondary cable into the probe amplifier as
shown in
Figure 7
Figure 7.
Connecting the N2820A's Secondary Cable
Making Measurements
Quick Start
2
25