The 3 Steps To Set Up And Make Measurements - Keysight N9030A Measurement Manual

The 3 Steps to Set Up and Make Measurements

All measurements can be set up using the following three steps. The sequence starts
at the Mode level, is followed by the Measurement level, then finally, the result
displays may be adjusted.
Table 1-1 The 3 Steps to Set Up and Make a Measurement
Step
1 Select and Set Up the
Mode
2 Select and Set Up the
Measurement
3 Select and Set Up a
View of the Results
NOTE
A setting may be reset at any time, and will be in effect on the next measurement
cycle or view.
Table 1-2 Main Keys and Functions for Making Measurements
Step
1 Select and set up a mode.
2 Select and set up a
measurement.
Action
a. Press Mode.
b. Press Analog Demod.
c. Press Mode Preset.
d. Press Mode Setup.
a. Press Meas.
b. Select the specific measurement
to be performed.
c. Press Meas Setup.
Press View/Display. Select a
display format for the current
measurement data.
Primary Key
Mode
Meas
9
Demodulating AM, FM, ΦM, FM Stereo/RDS Signals
Setting Up and Making a Measurement
Notes
All licensed, installed modes
available are shown under the Mode
key.
Using Mode Setup, make any
required adjustments to the mode
settings. These settings will apply to
all measurements in the mode.
The measurement begins as soon as
any required trigger conditions are
met. The resulting data is shown on
the display or is available for export.
Use Meas Setup to make any
required adjustment to the selected
measurement settings. The settings
only apply to this measurement.
Depending on the mode and
measurement selected, other
graphical and tabular data
presentations may be available.
X-Scale and Y-Scale adjustments
may also be made now.
Setup Keys
Mode Setup,
FREQ Channel
Meas Setup
Related Keys
System
Sweep/Control,
Restart, Single, Cont