General Information Introduction - Keysight N2820A User Manual

1 General Information
Introduction
Introduction
To Clean the Probe
Disconnect the probe from the
oscilloscope and clean the probe
with a soft cloth dampened with a
mild soap and water solution. Make
sure that the probe is completely dry
before reconnecting it to an
oscilloscope.
6
The N2820A and N2821A probes are shipped in a case. When you
receive the probe, inspect it as described in
Probe" on page 12.
Figure 1 shows the different components of the N2820A and
N2821A probes. The N2820A two-channel probe, with its two
internal, parallel differential amplifiers, provides simultaneous low
and high gain views. The N2821A also includes two amplifiers and
its main output can be switched between these two views. Before
using an N2820A probe, connect the secondary cable as described
in "Quick Start" on page 23. The N2821A single-channel probe
looks identical to the N2820A but does not include the secondary
cable. The accessories provided with the probes are shown in
Figure 2 on page 10.
Figure 1 Probe Parts Identification
"Inspecting the
N2820/1A User's Guide