Filter, Averaging; Analog Low Pass Filter; Digital Interfaces - MICRO-EPSILON capaNCDT 6200 Operating Instructions Manual

Ethernet Interface
6.5.8
Average type
It is recommended, to use averaging for statical measuring or slowly changing measuring values. An avera-
ging reduces noise or suppresses distortions in measuring values.
6.5.9
Filter
6.5.10
Ethernet
Settings
Ethernet/
EtherCAT
capaNCDT 6200

Filter, Averaging

Off
Moving Value
Arithmetic Value
Median Value
Dynamic noise rejection

Analog Low Pass Filter

active / inactive Switches the deep pass filter with 20 Hz limit frequency on analog output

Digital Interfaces

IP settings Address type
IP address
Subnet mask
Default Gateway
DHCP Host Name Value
Port settings Data port
MAC address
UUID
Operating mode Ethernet / EtherCAT
after start
Designation of averaging type.
Averaging number indicates,
Value range 2 / 3
about how many current measu-
ring values should be averaged
/ 4 / 5 / 6 / 7 / 8
in the controller, before a new
measuring value is output.
static IP address Values for IP address / Gateway
/ DHCP / Subnet mask. For static IP ad-
dress only
Value
Value
Value
Value
Value
Value
Page 80