Automatic Shutdown Relay - Chrysler 1997 Stratus Convertible RHD Service Manual

IGNITION COIL FAS-
8D - 18 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
(7) Install throttle and speed control (if equipped)
cables.
(8) Attach electrical connectors to sensors.
(9) Tighten air inlet tube clamps to 3 N·m
5 in. lbs.) torque.
(10) Connect negative terminal to auxiliary jumper
terminal.
SPARK PLUG TUBES
The spark plugs tubes are pressed into the cylinder
head. Sealant is applied to the end of the tube before
installation. For engine information, refer to Group
9, Engines.
IGNITION COIL—2.4L
The electronic ignition coil pack attaches directly
to the valve cover (Fig. 39).
REMOVAL
(1) Disconnect electrical connector from coil pack.
(2) Remove coil pack mounting nuts.
(3) Remove coil pack.
INSTALLATION
(1) Install coil pack on valve cover.
(2) Transfer spark plug cables to new coil pack.
The coil pack towers are numbered with the cylinder
identification. Be sure the ignition cables snap onto
the towers.
Fig. 39 Electronic Ignition Coil Pack—2.4L
IGNITION COIL—2.5L
The ignition coil is located in the distributor hous-
ing (Fig. 40).
If ignition coil is defective, replace distributor
assembly. Refer to Distributor Service.
ELECTRICAL CONNECTOR
TENERS
1 (25
IGNITION COIL
BATTERY POSITIVE BATTERY GROUND AIR CLEANER TCM PCM PDC
Fig. 40 Ignition Coil

AUTOMATIC SHUTDOWN RELAY

The relay is located in the Power Distribution Cen-
ter (PDC) (Fig. 41). The PDC is located in the engine
compartment. For the location of the relay within the
PDC, refer to the PDC cover for location. Check elec-
trical terminals for corrosion and repair as necessary.
Fig. 41 Power Distribution Center (PDC)
DISTRIBUTOR HOUSING COIL TOWER
JX