8K - 8
WINDSHIELD WIPERS AND WASHERS
REMOVAL AND INSTALLATION
MULTI-FUNCTION SWITCH
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove the upper steering column cover. Refer
to steering column cover removal procedures below.
(3) Remove multi-function switch mounting screws
(Fig. 10).
(4) Disconnect wire connectors. Lift the switch
straight up to remove.
INSTALLATION
For installation, reverse the above procedures.
(1) Tighten multi-function switch to column retain-
ing screws to 2.3 N·m (20 in. lbs.) torque.
(2) Tighten steering column cover retaining screws
to 2 N·m (17 in. lbs.) torque.
WASHER NOZZLE
REMOVAL
To replace nozzle, disconnect washer fluid hose.
Using a needle nose pliers, squeeze together the lock-
ing tabs on the nozzle.
VIEW Y
INSTALLATION
For installing make sure that both locking tabs are
securely snapped into position. Connect washer fluid
hose. If no washer spray, check fluid hoses kinks or
leaks (Fig. 11).
Fig. 11 Washer Fluid Hose Location
VIEW Z
Fig. 10 Multi-Function Switch
JX