Chrysler 1997 Stratus Convertible RHD Service Manual page 384

MOUNTING SCREWS
8R - 2 POWER SEATS
REMOVAL AND INSTALLATION (Continued)
Fig. 2 Switch Removal
Fig. 3 Seat Motor Switch Test
REMOVAL AND INSTALLATION
SEAT ASSEMBLY
REMOVAL
(1) Remove adjuster attaching bolts from floor pan.
Move seat as necessary for access.
(2) Disconnect battery negative cable.
(3) Disconnect wiring harness power lead at car-
pet.
(4) Remove assembly from vehicle.
INSTALLATION
For installation, reverse the above procedure.
Install and torque mounting bolts and nuts to 60 to
80 N·m (44 to 59 ft. lbs.). Connect the battery nega-
tive cable and check seat operation.
SEAT SWITCH
REMOVAL
(1) Remove left cushion side shield (Fig. 2).
(2) Disconnect wiring from switch.
(3) Remove the seat and recliner switch knobs.
(4) Remove attaching screws and switch from
bezel.
INSTALLATION
For installation, reverse the above procedure.
SEAT TRACK
REMOVAL
(1) Seat removed from vehicle. Using a clean area
to place seat.
(2) Remove two seat back mounting screws and
also remove two seat back recliner screws (Fig. 4).
(3) Remove four seat track mounting screws from
cushion pan.
(4) Remove track from seat.
JX