Chrysler 1997 Stratus Convertible RHD Service Manual page 944

POWER POWER STEERING PUMP STEERING PULLEY PUMP
POWER POWER SPECIAL TOOL 6936 STEERING STEERING PUMP PULLEY PUMP
19 - 30 STEERING
DISASSEMBLY AND ASSEMBLY (Continued)
(1) Mount power steering pump in a vise using the
power steering pump mounting bracket.
(2) Place power steering pump pulley squarely on
end of power steering pump shaft (Fig. 54).
Fig. 54 Pulley Positioned On Shaft Of Power
Steering Pump
(3) Place Installation Spacer, Special Tool 6936,
(Fig. 55) on top of the power steering pump pulley.
Fig. 55 Special Tool 6936 Correctly Installed On
Power Steering Pump Pulley
(4) Mount Installer, Special Tool C-4063 in internal
threads of the power steering pump shaft and
against Special Tool 6936 on power steering pump
pulley (Fig. 56).
(5) Ensuring that special tool and pulley remain
aligned with pump shaft, force pulley onto power
steering pump shaft until Special Tool 6936 is
against the end of the power steering pump shaft.
When Special Tool 6936 is against the shaft of
the power steering pump Special Tool C-4063
will no longer be able to be turned.
(6) Remove Installer, Special Tool C-4063 from
power steering pump.
BE STARTED SQUARELY ON SHAFT OF POWER STEERING PUMP PULLEY MUST POWER STEERING PUMP AS SHOWN SPECIAL C-4063 TOOL WRENCHES
Fig. 56 Installing Pulley On Shaft Of Power Steering
(7) Install power steering pump and mounting
bracket back on engine. Refer to Power Steering
Pump Installation in the Power Steering Pump Ser-
vice Procedures section in this group of the service
manual for required procedure.
POWER STEERING PUMP MOUNTING BRACKET
DISASSEMBLE
(1) Remove power steering pump from engine.
Refer to Power Steering Pump Removal in the Power
Steering Pump Service Procedures section in this
group of the service manual for required procedure.
CAUTION: Do not hammer on power steering
pump pulley or shaft to remove power steering
pump pulley. This will damage the pulley and the
power steering pump.
(2) Mount Puller, Special Tool C-4333 or C-4068 on
power steering pump pulley. Mount power steering
pump and puller in a vise (Fig. 57) to keep shaft of
power steering pump from turning when removing
pulley.
(3) Remove the drive pulley from the shaft of the
power steering pump.
(4) Remove bolts attaching power steering pump to
mounting bracket.
(5) Remove power steering pump from mounting
bracket.
ASSEMBLE
(1) Install power steering pump on mounting
bracket. Install the power steering pump to mounting
bracket attaching bolts. Torque the mounting bolts to
54 N·m (40 ft. lbs).
POWER
POWER STEERING
Pump
STEERING PUMP
PUMP
BRACKET
JX