Chrysler 1997 Stratus Convertible RHD Service Manual page 138

MASTER MOUNTING ASSEMBLY CYLINDER ATTACHING NUTS BRACKET MASTER
5 - 36 BRAKES
REMOVAL AND INSTALLATION (Continued)
(3) If equipped, remove the vehicle's wiring har-
ness connector from the speed control servo. Remove
the 2 speed control servo mounting bracket to strut
tower attaching nuts (Fig. 90). Without removing
speed control cable from servo, move speed control
servo out of the way.
Fig. 90 Speed Control Servo Attachment
(4) Remove the vacuum harness connector and
electrical connector from the purge solenoid (Fig. 91).
Remove purge solenoid from vehicle.
Fig. 91 Purge Control Solenoid
(5) Remove the air inlet resonator and air inlet
hose (Fig. 92) as an assembly, from the engine
mounted air inlet resonator and air cleaner housing
(Fig. 92).
(6) Remove the vacuum hoses (Fig. 93) from the
check valve located on the power brake vacuum
booster.
(7) Remove EGR valve transducer assembly and
vacuum hoses (Fig. 94) from the EGR valve. Valve
removal is necessary for required clearance to
remove power brake vacuum booster from vehi-
cle and not damage transducer during removal.
SPEED LEFT CYLIN- TOWER DER STRUT CONTROL SERVO ELECTRICAL LEFT PURGE SOLE- CONNECTOR VACUUM HARNESS TOWER STRUT NOID AIR VACUUM HOSE FROM SPEED CONTROL SERVO AIR CLEANER HOUSING INTAKE MANIFOLD AIR INLET RESONATOR INLET LEFT SHOCK TOWER (ENGINE MOUNTING) AIR INLET HOSE RESONATOR
HEATER
HOSES
Fig. 92 Air Inlet Resonator And Tube
Fig. 93 Vacuum Hose Attachment To Check Valve
Fig. 94 EGR Valve Transducer Assembly
SPEED CONTROL VACUUM EGR VALVE TRANS- RESERVOIR HOSE DUCER EGR VALVE
EGR
VALVE
VACUUM HOSE TO EGR
VALVE
JX