Chrysler 1997 Stratus Convertible RHD Service Manual page 984

KEY CYLINDER LOWER SHROUD TILT LEVER
IGNITION LOCK CYL-
INDER
21 - 16 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 17 Remove Lower Shroud From Ignition
Cylinder
Fig. 18 Lower Shroud Removal
Fig. 19 Interlock Cable and Connector
(18) Remove interlock cable from underside of
instrument panel.
LOWER SHROUD INTERLOCK CABLE IGNITION SWITCH
INSTALLATION
CAUTION: When installing interlock cable assem-
bly, care must be taken not to bend exposed cable
wire and slug at shifter end of cable.
(1) Route interlock cable into lower dash panel.
(2) Turn the ignition switch to the RUN position.
(3) Install the interlock cable into the interlock
housing at the steering column (Fig. 20). Verify the
cable snaps into the housing.
Fig. 20 Interlock Cable At Housing
(4) Install interlock cable into routing clip located
along cable housing.
(5) Route interlock cable to the console.
(6) Install the cable core end to the plastic cam of
the shifter mechanism. Snap the shifter/ignition
interlock cable end fitting into the groove in the gear-
shift mechanism.
(7) Adjust the Shifter/Ignition Interlock System.
See Interlock System Adjustment, in this section of
service manual.
(8) Perform the Shifter/Ignition Interlock System
operation check, as described in the beginning of this
section.
(9) Install console assembly. Refer to Group 23,
Body.
(10) Install the gearshift knob set screw and knob.
(11) Tilt wheel to full down position and install
upper steering column shroud.
(12) Hold tilt wheel lever down and slide lower
shroud in at column.
(13) Install screws at lower steering column
shroud.
(14) Install lower knee bolster screws and knee
bolster.
(15) Install screws holding instrument panel top
cover to center of instrument panel.
(16) Install center bezel.
INTERLOCK CABLE
JX