Chrysler 1997 Stratus Convertible RHD Service Manual page 771

INSTALL CAMSHAFT TIMING MARKS SPROCKET MOVE CAMSHAFT CAMSHAFT CRANKSHAFT AT TDC 1/2 NOTCH LOCATION 1/2 NOTCH LOCATION BELT TO BELT SLACK DIRECTION SPROCKET SPROCKET CAMSHAFT TAKE EXHAUST IN INTAKE THIS UP
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 57 Camshaft Sprocket Alignment
Fig. 58 Timing Belt—Installation
(2) Remove engine support module. Refer to
Removal and Installation procedure in this section.
(3) Remove collar from rear of pan and transmis-
sion.
(4) Remove oil pan.
(5) Clean oil pan and all gasket surfaces.
SEALANT AT THE PARTING LINE OF THE PLACE A 3 MM (1/8 INCH) BEAD OF OIL PICK-UP TUBE OIL PUMP BODY TO ENGINE BLOCK
INSTALLATION
Fig. 59 Oil Pan Sealing
Fig. 60 Oil Pan Gasket Installation
(1) Apply Mopar Silicone Rubber Adhesive Sealant
or equivalent at the oil pump to engine block parting
line (Fig. 59).
(2) Install the oil pan gasket to the block (Fig.
60).
(3) Install pan and tighten the screws to 12 N·m
(105 in. lbs.).
CAUTION: Torque procedure for the collar must be
followed or damage could occur to oil pan or collar.
(4) Install the 2 center collar to oil pan bolts.
Torque to 3 N·m (30 in. lbs.)
(5) Install collar to transmission bolts and tighten
to 108 N·m (80 ft. lbs.).
(6) Install the 2 remaining collar to pan bolts.
Starting with the center bolts and working outward
torque all 4 bolts to 34 N·m (250 in. lbs.).
(7) Install engine
Removal and Installation procedure in this section.
SEALER WITH OIL PAN WINDAGE GASKET TRAY
2.4L ENGINE
support module. Refer
9 - 35
to