Speed Sensor-Input; Speed Sensor-Output; Transaxle; Transmission Control Module - Chrysler 1997 Stratus Convertible RHD Service Manual

INPUT VALVE BODY (TURBINE) SENSOR SPEED
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 30 Remove Transmission Range Sensor
INSTALLATION
(1) For installation, reverse removal procedure.
Tighten TRS retaining screw to 5 N·m (45 in. lbs.)
Reseal transaxle oil pan using RTV.

SPEED SENSOR-INPUT

CAUTION: When disconnecting speed sensor con-
nector, be sure that the weather seal does not fall
off or remain in old sensor.
The input speed sensor is located to the left of the
manual shift lever (Fig. 31).
Fig. 31 Input (Turbine) Speed Sensor

SPEED SENSOR-OUTPUT

CAUTION: When disconnecting speed sensor con-
nector, be sure that the weather seal does not fall
off or remain in old sensor.
The output speed sensor is located to the right of
the manual shift lever (Fig. 32).
RANGE TRANSMISSION SEN- SOR OUTPUT SPEED SENSOR

TRANSMISSION CONTROL MODULE

Do not interchange transmission control modules
with previous year transmission control modules. If a
same year TCM is being used from a different vehi-
cle, the following procedures must be performed:
• Quick Learn Procedure
• Torque Converter Clutch Break-in Procedure
• Electronic Pinion Procedure
The transmission control module is next to the bat-
tery on the left side of vehicle, in the engine compart-
ment. It is held in place by three mounting screws.
NOTE: If the transmission control module has been
replaced, the following procedures must be per-
formed:
• Quick Learn Procedure: This procedure will
allow the transmission control module to learn the
characteristics of the vehicle.
• Electronic Pinion Factor Procedure: This proce-
dure will reprogram the TCM to compensate for dif-
ferent tire sizes and final drive ratios.
• Converter Clutch Break-In Procedure: This pro-
cedure will reset the torque converter clutch status.
2.4 LITER ENGINE
REMOVAL
(1) Disconnect battery negative cable at the left
strut tower.
(2) Remove air cleaner clamps and air cleaner.
(3) Remove TCM 60 way connector.
(4) Remove three mounting screws.
(5) Remove TCM (Fig. 33).
INSTALLATION
(1) For installation, reverse removal procedure.

TRANSAXLE

Fig. 32 Output Speed Sensor
21 - 19