Chrysler 1997 Stratus Convertible RHD Service Manual page 184

SEALING VEHICLE WIRING HAR- REAR REAR TRUNK FLOOR GROMMET FENDER SPEED INNER WHEEL SENSOR CABLE NESS SPEED SENSOR CABLE
5 - 82 BRAKES
REMOVAL AND INSTALLATION (Continued)
REAR WHEEL SPEED SENSORS
REMOVE
(1) Unplug the speed sensor cable connector from
the vehicle wiring harness (Fig. 37). Access for
speed sensor cable to vehicle wiring harness
connection is in the trunk of the vehicle.
Fig. 37 Rear Speed Sensor Cable Connection To
Vehicle Wiring Harness
(2) Raise vehicle on jack stands or centered on a
frame contact type hoist. See Hoisting in the Lubri-
cation and Maintenance section of this manual, for
the required lifting procedure to be used for this
vehicle.
(3) Remove the rear tire and wheel assembly from
the vehicle.
(4) Remove speed sensor cable sealing grommet
retainer (Fig. 38) from the rear frame rail of the
vehicle. Then remove speed sensor cable sealing
grommet and cable from hole in body of vehicle.
Fig. 38 Rear Speed Senor Cable Attachment To
BRAKE SEALING BOLT HOSE FLEX GROMMET RETAINER GER REAR OF PASSEN- MENT BACK SEAT COMPART-
Body
CONTROL UPPER BRAKE FLEX HOSE BRAKE DRUM SPEED ARM BRACKET SENSOR CABLE SPEED SENSOR CABLE ROUTING BOLT
(5) Remove speed sensor routing clips from the
rear upper control arm and brake flex hose routing
bracket (Fig. 39).
Fig. 39 Speed Sensor Cable Attachment To Rear
Suspension
(6) Remove the rear speed sensor head from the
rear brake support plate (Fig. 40).
Fig. 40 Rear Speed Sensor Head Attachment To
Brake Support Plate
INSTALL
CAUTION: Proper installation of wheel speed sen-
sor cables is critical to continued system operation.
Be sure that cables are installed in retainers. Fail-
ure to install cables in retainers as shown in this
section may result in contact with moving parts
and/or over extension of cables, resulting in an
open circuit.
(1) Install speed sensor head into brake support
plate (Fig. 40).
SPEED SENSOR CABLE CLIPS SHOCK ABSORBER SPEED SENSOR BOLT BOLT HEAD
JX