Chrysler 1997 Stratus Convertible RHD Service Manual page 242

CHECK REPEAT OUTPUT VOLT- 8W REFER TO GROUP AND WIRE SHORT. REPAIR FUSE LINK REPEAT TIONS GOOD? CONNEC- VOLTAGE TEST WIRING BROKEN? WIRE REPAIR WIRE BROKEN WIRE WIRING GRAMS. OUTPUT YES AGE TEST DIA- FOR NO YES NO CHECK DISCONNECT CHECK SHORT CIRCUIT REPEAT CHECK STARTER MOTOR, BATTERY. REPEAT TIONS CUIT IN FEED SHORT
8C - 8 CHARGING SYSTEM
DIAGNOSIS AND TESTING (Continued)
FOR VOLTAGE TEST CONNECTOR DROP TEST FUSE LINK WIRE? YES AT WIRING VOLTAGE NO CIR- REPAIR WIRE BLOWN OUTPUT REPLACE IN WIRE FIELD REPEAT OUTPUT VOLT- GENERATOR, CONNEC- NO REPAIR FUSE LINK. GENERATOR. AGE TEST TRAIN CONTROL MODULE PIN 6 WITH ENGINE OFF, CHECK POWER- 6 PCM CONNECTOR TO PIN 1 ON GENERATOR CHECK WIRE HARNESS RESISTANCE FROM PIN YES PERFORM VOLTAGE DROP REPLACE PCM FOR CORROSION OR DAMAGE THAN IF
Fig. 6 Voltage Drop Test
OHMS LESS 5 REPEAT OUTPUT TEST REFER TO GROUP 8W, WIR- REPAIR TEST IF GREATER THAN A142 NO ING DIAGRAMS OHMS REPEAT OUTPUT VOLT- CONNECTOR 5 CIRCUIT. REPAIR PIN REPLACE YES GENERATOR
VOLTAGE
DROP ABOVE
0.6 VOLTS?
CUIT A142 ON THE GENERA- MEASURE VOLTAGE AT CIR- WITH AGE TEST LESS THAN VOLTAGE 10 VOLTS? ENGINE REPAIR WIRE MEASURE VOLTAGE AT K-20 TERMI- YES YES JUMPER WIRE FROM BATTERY WITH ENGINE OFF, CONNECT CUIT TERMINAL ON THE GEN- POSITIVE POST TO A142 CIR- RUNNING, DAMAGE ON PIN CORROSION THAN K-20 VOLTAGE TOR. NAL ON THE GENERATOR. NO REFER TO CHARGING DIAG- YES VOLTS? NO LESS
CHECK POWERTRAIN
TROL MODULE PIN 4 FOR COR-
ROSION OR DAMAGE.
AT 10 OR WIRE 4? CHECK ERATOR. NOSTIC MANUAL NO CIRCUIT? OPEN NO WIRE K-20
CON-
JX