Chrysler 1997 Stratus Convertible RHD Service Manual page 139

JX
BRAKE VACUUM BOOSTER BRAKE FLUID RESERVOIR CYLINDER MASTER ASSEMBLY MASTER CYLINDER MOUNTING NUTS ROUTING CLIP
REMOVAL AND INSTALLATION (Continued)
(8) Remove the vehicle's wiring harness connector
from the master cylinder brake fluid level sensor
(Fig. 95).
Fig. 95 Master Cylinder Brake Fluid Level Sensor
(9) Remove the 2 nuts (Fig. 96) attaching the mas-
ter cylinder assembly to the power brake vacuum
booster.
Fig. 96 Master Cylinder Mounting
CAUTION: When removing the routing clip and
brake tubes from the mounting stud do not bend or
kink the chassis brake line tubes.
(10) Remove the routing clip and chassis brake
tubes (Fig. 96) (as an assembly) from the mounting
stud for the master cylinder.
(11) Without removing the brake tubes from mas-
ter cylinder, remove it from the power brake vacuum
booster. Then carefully lower master cylinder and
brake tubes as an assembly until it is positioned on
top of the transaxle (Fig. 97).
(12) Locate the vacuum booster input rod to brake
pedal attachment under instrument panel. Position a
small screwdriver between the retaining clip center
BRAKE TUBES MASTER CYLINDER FLUID LEVEL SENSOR
LEFT SHOCK
TOWER
POWER UUM BOOSTER BRAKE VAC- TRANSAXLE
BRAKE PEDAL
Fig. 97 Master Cylinder Assembly Positioned For
Booster Removal
tang and the retaining clip (Fig. 98). Rotate screw-
driver enough to allow retaining clip center tang to
pass over end of brake pedal pin. Then pull retaining
clip off brake pedal pin. Discard retaining clip.
Replace only with a new retaining clip when
assembled.
Fig. 98 Input Rod Retaining Pin
(13) Remove the 4 nuts attaching the vacuum
booster to the dash panel. Nuts are accessible from
under dash panel in area of the steering column and
pedal bracket assembly (Fig. 99).
(14) Slide vacuum booster forward until mounting
studs clear dash panel and then tilt up and rotate
toward center of vehicle to remove (Fig. 100).
CAUTION: Do not attempt to disassemble the
power brake vacuum booster it is to be serviced
ONLY as a complete assembly.
MASTER CYLINDER AND AND STRUT TOWER LEFT BRAKE TUBES FRAME FRONT
BRAKES 5 - 37
SCREWDRIVER INPUT ROD RETAINING CLIP BRAKE PEDAL PIN
RAIL