Chrysler 1997 Stratus Convertible RHD Service Manual page 353

COURTESY LAMP HOUSING COURTESY LAMP HOUSING COURTESY LAMP LENS DOOR TRIM PANEL DOOR TRIM PANEL
JX
REMOVAL AND INSTALLATION (Continued)
(2) Pull courtesy lamp from door trim panel (Fig.
8).
(3) Disengage wire connector from courtesy lamp
bulb socket.
(4) Separate courtesy lamp from vehicle.
Fig. 7 Courtesy Lamp Lens
Fig. 8 Courtesy Lamp
INSTALLATION
(1) Position courtesy lamp from vehicle.
(2) Engage wire connector to courtesy lamp bulb
socket.
(3) Push courtesy lamp into door trim panel (Fig.
8).
(4) Insert front edge of courtesy lamp lens to lamp
housing.
(5) Snap lamp lens into lamp housing.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
REMOVAL
(1) Remove upper deck molding. Refer to Group
23, Body, for proper procedure.
UPPER DECK MOLDING WIRE CONNECTOR WIRE HARNESS CHMSL
(2) Remove screws holding CHMSL assembly to
upper deck molding (Fig. 9).
(3) Remove trunk trim panel as necessary to dis-
engage CHMSL wire connector.
(4) Separate CHMSL from upper deck molding.
Fig. 9 Center High Mount Stop Lamp
INSTALLATION
(1) Position CHMSL to upper deck molding.
(2) Engage CHMSL wire connector and reposition
trunk trim panel.
(3) Install screws holding CHMSL assembly to
upper deck molding.
(4) Install upper deck molding. Refer to Group 23,
Body, for proper procedure.
LICENSE PLATE LAMP
REMOVAL
(1) Remove screws holding license plate lamp to
rear bumper fascia.
(2) Separate license plate lamp from rear fascia
(Fig. 10).
(3) Rotate socket counterclockwise one quarter
turn.
(4) Pull socket from back of lamp.
(5) Separate license plate lamp from vehicle.
INSTALLATION
(1) Position license plate lamp to vehicle.
(2) Push socket into back of lamp.
(3) Rotate socket clockwise one quarter turn.
(4) Position license plate lamp to rear fascia.
(5) Install screws holding license plate lamp to
rear bumper fascia.
LAMPS 8L - 15