Chrysler 1997 Stratus Convertible RHD Service Manual page 905

POSITION THROTTLE SENSOR THROTTLE SHAFT
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 71 Indexing Throttle Position Sensor—2.5L
Fig. 72 Throttle Position Sensor and Idle Air Control
Motor—2.0L
Fig. 73 Throttle Position Sensor and Idle Air Control
Motor—2.4L
IDLE AIR CON-
TROL MOTOR
Engine
TABS RETAINER SCREWS IDLE AIR CONTROL MOTOR
Fig. 74 Throttle Position Sensor and Idle Air Control
INSTALLATION
(1) The new idle air control motor has a new
O-ring installed on it. If pintle measures more than 1
inch (25 mm) it must be retracted. Use the DRB AIS
Motor Open/Close Test to retract the pintle (battery
must be connected.)
(2) Carefully place idle air control motor into
throttle body.
(3) Install mounting screws. Tighten screws to 3
N·m (25 in. lbs.) torque.
(4) Install throttle body. Refer to Throttle Body in
this section.
(5) Attach electrical connectors to idle air control
motor and throttle position sensor.
(6) Install EVAP purge hose to throttle body nipple.
INTAKE AIR TEMPERATURE SENSOR—2.4L
The intake air temperature sensor threads into the
intake manifold plenum (Fig. 75).
REMOVAL
(1) Remove air inlet resonator.
(2) Reaching through intake manifold from throttle
body end, disconnect sensor connector.
(3) Remove sensor.
INSTALLATION
(1) Install sensor. Tighten sensor to 28 N·m (20 ft.
lbs.) torque.
(2) Attach electrical connector to sensor.
(3) Install air inlet resonator.
INTAKE AIR TEMPERATURE SENSOR—2.5L
The intake air temperature sensor threads into the
intake manifold plenum (Fig. 76).
FUEL SYSTEM
Motor—2.5L
14 - 51