Chrysler 1997 Stratus Convertible RHD Service Manual page 178

DRIVESHAFT FRONT SPLASH SHIELD CROSSMEMBER SUSPENSION HCU MOUNTING BRACKET
5 - 76 BRAKES
REMOVAL AND INSTALLATION (Continued)
(7) Remove right side engine compartment splash
shield (Fig. 15) from the vehicle.
Fig. 15 Right Side Splash Shield
(8) Remove the HCU heat shield (Fig. 16) from the
HCU mounting bracket.
Fig. 16 HCU Heat Shield
(9) Disconnect the 6 way connector from the HCU
wiring harness and the 10 way connector from the
relay box located on the HCU (Fig. 17).
(10) Remove the brake tube routing clip (Fig. 18)
from the HCU mounting bracket. Then remove the 2
brake tubes coming from master cylinder and the
brake tube going to the left front wheel (Fig. 18) from
the HCU ports.
(11) Remove the 2 rear brake tubes from the pro-
portioning valves and the right front brake tube from
the outlet port of the HCU (Fig. 19).
STEERING GEAR HCU ATTACHING SHIELD HEAT BOLT
EXHAUST
PIPE
6–WAY RELAY RIGHT FRONT BRAKE BRAKE HCU BRAKE TOR CONNECTOR BOX TUBE PUMP/MO- TUBE TUBE ROUTING CLIP BRAKE TUBES FROM MASTER
Fig. 17 Electrical Connections At HCU And Relay
Fig. 18 Brake Tubes At HCU
Fig. 19 Rear Brake Tubes And Right Front Brake
Tube At HCU
10–WAY RELAY BOX CON- REAR BRAKE TUBES ATTACHING BOLT PROPORTIONING CYLINDER NECTOR VALVES LEFT BRAKE TUBE TO HCU
Box
HCU WHEEL FRONT
JX