Chrysler 1997 Stratus Convertible RHD Service Manual page 182

MOUNTING BOLT CAB AIR CONDITION- ING LINE CAB
5 - 80 BRAKES
REMOVAL AND INSTALLATION (Continued)
(3) Remove the 2 bolts (Fig. 30) attaching the CAB
mounting bracket to inner fender and front upper
crossmember.
Fig. 30 CAB Bracket To Engine Compartment Mounting
(4) Remove the CAB from the vehicle.
INSTALL
(1) Install the CAB and the mounting bracket
assembled, on the right inner fender of the vehicle.
(Fig. 30).
(2) Install the 2 bolts mounting the CAB bracket
to the vehicle. Tighten both mounting bolts to a
torque of 9 N·m (75 in. lbs.).
(3) Install 60-way wiring harness connector (Fig.
29) into the CAB 60-way connector by hand until
seated as far as possible. Then use CAB connector
retaining bolt (Fig. 29) to fully seat wiring harness
connector into the CAB.
(4) Tighten the 60-way connector retaining bolt
(Fig. 29) to a torque of 4 N·m (35 in. lbs.).
FRONT WHEEL SPEED SENSOR
REMOVE
(1) Raise vehicle on jack stands or centered on a
frame contact type hoist. See Hoisting in the Lubri-
cation and Maintenance section of this manual, for
the required lifting procedure to be used for this
vehicle.
(2) Remove the tire and wheel assembly from the
vehicle.
(3) Remove the speed sensor cable routing bracket
(Fig. 31) from the steering knuckle. Remove the wir-
ing harness sealing grommet retainer and speed sen-
sor routing bracket from the inner fender.
(4) Remove speed sensor sealing grommet from the
inner fender (Fig. 32). Then unplug the speed sensor
cable from the vehicle wiring harness (Fig. 32).
(5) Remove bolt (Fig. 33) attaching the speed sen-
sor head to the steering knuckle. Then remove speed
sensor head from steering knuckle
MOUNTING BRACKET MOUNTING BOLT GROMMET RETAINER AND CABLE ROUTING BRACKET WHEEL SPEED SEN- SPEED ROUTING BRACKET SOR CABLE SENSOR
WHEEL SPEED SEN- SEALING VEHICLE WIRING HARNESS INNER FENDER GROMMET SOR CABLE
SPEED STEERING BOLT KNUCKLE SENSOR CABLE
Fig. 31 Speed Sensor Cable Routing Brackets
Fig. 32 Wheel Speed Sensor Connection To Vehicle
Wiring Harness
Fig. 33 Speed Sensor Head Attachment To Steering
BOLT STEERING
RETAINING GROMMET BRACKET FRONT SHOCK ABSORBER
SPEED
TONE WHEEL
Knuckle
KNUCKLE B OLT ABSORBER SHOCK
JX
SENSOR HEAD
DRIVESHAFT