Chrysler 1997 Stratus Convertible RHD Service Manual page 151

CENTER CONSOLE WIRING PARK VEHICLE WIRING HARNESS 10–WAY CONNECTOR CENTER CONSOLE PASSENGER SEAT BRAKE DRIVER SEAT ASSEMBLY HARNESS LEVER
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 134 Console Wiring Harness Connector
(9) Reload the adjuster mechanism on the park
brake lever using the following procedure.
• Ensure the park brake lever is in the full down
position when attempting to pull on park brake
lever output cable (Fig. 135).
• Grasp the park brake lever output cable (Fig.
135) by hand and pull upward.
• Continue to pull upward on cable until a 15/64
drill bit can be inserted in the adjuster mechanism
as shown in (Fig. 135). This will lock-out the auto
adjuster mechanism removing the tension from the
park brake lever output cable. This will then allow
the rear park brake cables to be easily removed from
the equalizer.
NOTE: If the output cable of the park brake mech-
anism will not move when pulled on, first, be sure
the park brake lever is in the full down position. If
park brake lever is in the full down position and the
output cable will not move, use the following proce-
dure to reload the adjuster mechanism.
Using a screw driver (Fig. 136) push down on the
end of the clutch spring where shown (Fig. 136).
While end of clutch spring is held down, pull out-
ward on park brake mechanism output cable.
If output cable can not be pulled out of park
brake mechanism, by pulling directly on output
cable, use a screwdriver inserted in tension equal-
izer (Fig. 136) to assist in pulling on cable.
(10) Remove both rear wheel park brake cables
from the park brake cable tension equalizer (Fig.
137).
PARK AUTOMATIC PARK BRAKE CABLE TEN- REAR WHEEL PARK BRAKE PARK BRAKE LEVER OUT- PUSH DOWNWARD ON END PARK BRAKE LEVER OUT- USING PARK BRAKE LEVER MECH- PARK BRAKE LEVER OUT- PARK OF CLUTCH SPRING HERE. PARK BRAKE HAND LEVER PARK BRAKE HAND LEVER CLUTCH SPRING END BRAKE BRAKE SION EQUALIZER CLUTCH SPRING 15/64 DRILL BIT SCREWDRIVER SCREWDRIVER MECHANISM PUT CABLE PUT CABLE PUT CABLE ASSEMBLY ADJUSTER ASSEMBLY CABLES LEVER LEVER ANISM
Fig. 135 Park Brake Lever Correctly Reloaded
Fig. 136 Releasing Clutch Spring
Fig. 137 Park Brake Cables At Tension Equalizer
BRAKES 5 - 49