Chrysler 1997 Stratus Convertible RHD Service Manual page 211

SUPPORT LOCK NUT BRACKET
JX
REMOVAL AND INSTALLATION (Continued)
(1) Loosen T-Bolt locking nut A and pivot bolt B to
remove and install Poly V belt and/or adjust belt ten-
sion (Fig. 36).
(2) Tighten adjusting bolt to adjust belt tension to
specification shown in belt tension chart (Fig. 40).
(3) Tighten T-Bolt locking nut A and pivot bolt B to
54 N·m (40 ft. lbs.) (Fig. 36).
Fig. 36 Air Conditioning Compressor and Generator
Belt Adjustment
POWER STEERING PUMP BELT
(1) From the top of the vehicle loosen pivot bolt C.
(2) From under the vehicle loosen locking bolts D
and E (Fig. 37).
(3) Install the belt. Adjust belt tension with 1/2 in.
breaker bar installed in adjusting bracket. See ten-
sion specification in chart (Fig. 40).
(4) Tighten locking bolt D to 54 N·m (40 ft. lbs.)
(Fig. 37).
(5) Tighten locking bolt E and the pivot bolt C to
54 N·m (40 ft. lbs.)
ACCESSORY DRIVE BELT—2.5L ENGINE
AIR CONDITIONING BELT AND GENERATOR
BELT
To remove and install the air conditioning compres-
sor and generator drive belt, first loosen the idler
pulley lock bolt, then turn the adjusting screw to
increase or decrease the idler pulley tension (Fig. 38).
To adjust the air conditioning and generator drive
belt, loosen the idler pulley bolt (Fig. 38) and adjust
belt tension by turning adjusting screw (Fig. 38).
Tighten pulley bolt to 54 N·m (40 ft. lbs.) after
adjustment.
ADJUSTING BOLT IDLER PIVOT BOLT LOCKING BOLT LOCKING BOLT LOCKING BOLT PIVOT BOLT
Fig. 37 Power Steering Belt Adjustment
Fig. 38 Air Conditioning Compressor and Generator
ADJUSTING BOLT
COOLING SYSTEM
Belt Idler
SQUARE 1/2 OPENING INCH
7 - 25