Chrysler 1997 Stratus Convertible RHD Service Manual page 935

WHEEL SPEED SEN- WHEEL SEALING VEHICLE WIRING HARNESS CABLE ROUTING HOLE INNER FENDER GROMMET EXTENSION RATCHET SOR CABLE SPEED SENSOR
JX
REMOVAL AND INSTALLATION (Continued)
(12) Remove the speed sensor cable sealing grom-
met from inner fender (Fig. 30). Then disconnect the
wheel speed sensor cable from the vehicle wiring har-
ness (Fig. 30). Push vehicle wiring harness back
through hole in inner fender and unclip wiring har-
ness trough from frame rail.
Fig. 30 Wheel Speed Sensor Cable Connection To
Vehicle Wiring Harness
(13) Remove bolt attaching top of power steering
pump front bracket to the cast aluminum mounting
bracket. Access to the top bolt is through the wheel
speed sensor cable routing hole (Fig. 31). To access
the bolt use a long extension and a 15 mm flex
socket.
Fig. 31 Access To Top Mounting Bolt For Power
Steering Pump
(14) Remove power steering pump drive belt from
power steering pump pulley.
(15) Remove power steering pump and front
mounting bracket as an assembly from the engine
and vehicle. Pump and mounting bracket is remov-
able by bringing it out through area between rear of
engine, driveshaft and front suspension crossmember.
RETAINING GROMMET BRACKET FRONT SHOCK STEERING KNUCKLE ABSORBER
BANJO BOLT O RING
SURE HOSE BANJO FITTING POWER STEERING PRES-
(16) Transfer required parts from removed power
steering pump, to replacement power steering pump.
INSTALL
(1) Install power steering pump and mounting
bracket as an assembly back in vehicle, using reverse
order of removal.
(2) Install power steering pump and front bracket
on the cast aluminum accessory drive engine bracket
(Fig. 27). Then loosely install the bolt at adjusting
slot (Fig. 27) mounting pump bracket to accessory
drive bracket.
(3) Loosely install the bolt mounting the power
steering pump to its rear mounting bracket (Fig. 28).
(4) Loosely install bolt attaching top of power
steering pump front bracket to the cast aluminum
accessory drive bracket. Access to install the bolt is
through the wheel speed sensor cable routing hole
(Fig. 31).
(5) Using a lint free towel, wipe clean all open
power steering hose ends, and power steering pump
fittings.
(6) Install a new O-ring on the end of power steer-
ing pressure hose banjo fitting (Fig. 32).
Fig. 32 O-Ring Installed On Power Steering Hose
Banjo Fitting
(7) Install a new O-ring on the Banjo Fitting Bolt
for the power steering pressure hose Banjo Fitting
(Fig. 33)
(8) Lubricate both O-rings using fresh clean power
steering fluid.
NOTE: Pressure hose must be installed between
the front bracket of the power steering pump and
power steering pump pulley.
(9) Install the power steering pressure hose on the
power steering pump pressure fitting, and loosely
install the Banjo Fitting bolt.
STEERING 19 - 21