Chrysler 1997 Stratus Convertible RHD Service Manual page 346

8L - 8 LAMPS
REMOVAL AND INSTALLATION
ASH RECEIVER/CUP HOLDER LAMP BULB . . . 9
BACK-UP LAMP BULB . . . . . . . . . . . . . . . . . . . 10
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . 11
DOOR COURTESY LAMP BULB
FLOOR CONSOLE COURTESY LAMP BULB . . . 9
FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 9
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
CAUTION: Do not touch the glass of halogen
bulbs with fingers or other possibly oily surface,
reduced bulb life will result.
(1) Release hood latch and open hood.
(2) Remove screws holding headlamp module to
radiator closure panel.
(3) Separate headlamp module from radiator clo-
sure panel.
(4) Disengage wire connector from back of head-
lamp bulb.
(5) Rotate retaining ring counterclockwise one
quarter turn.
(6) Separate retaining ring from headlamp module.
(7) Pull bulb from headlamp module (Fig. 1).
INSTALLATION
(1) Insert bulb into headlamp module.
(2) Position retaining ring to headlamp module.
(3) Rotate retaining ring clockwise one quarter
turn.
(4) Engage wire connector from back of headlamp
bulb.
(5) Position headlamp module to radiator closure
panel.
(6) Install screws holding headlamp module to
radiator closure panel.
(7) Verify proper headlamp alignment. Adjust as
necessary.
PARK AND TURN SIGNAL LAMP BULB
REMOVAL
(1) Release hood latch and open hood.
LAMP BULB SERVICE
INDEX
page
. . . . . . . . . . . 10
radiator closure panel.
sure panel.
turn.
INSTALLATION
panel.
radiator closure panel.
FRONT MAP LAMP BULB
GLOVE BOX LAMP BULB
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . 8
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . 11
LIGHTED PRNDL LETTER BEZEL . . . . . . . . . . . 9
PARK AND TURN SIGNAL LAMP BULB . . . . . . . 8
TAIL/STOP AND TURN SIGNAL LAMP BULB . . 10
Fig. 1 Headlamp Bulb
(2) Remove screws holding headlamp module to
(3) Separate headlamp module from radiator clo-
(4) Rotate socket counterclockwise one quarter
(5) Pull socket from back of lamp (Fig. 2).
(6) Pull bulb from socket.
(1) Push bulb into socket.
(2) Position socket into back of lamp (Fig. 2).
(3) Rotate socket clockwise one quarter turn.
(4) Position headlamp module to radiator closure
(5) Install screws holding headlamp module to
JX
page
. . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . 9