Chrysler 1997 Stratus Convertible RHD Service Manual page 925

JX
SERVICE PROCEDURES (Continued)
Wipe reservoir filler cap free of dirt. Then check
fluid level. The dipstick should indicate COLD when
fluid is at normal ambient temperature, approxi-
mately 21°C to 27°C (70°F to 80°F). In all pumps add
fluid as necessary, use only Mopar Power Steering
Fluid, or equivalent. DO NOT USE ANY TYPE
OF AUTOMATIC TRANSMISSION FLUID.
POWER STEERING PUMP INITIAL OPERATION
CAUTION: The fluid level should be checked with
engine off to prevent injury from moving compo-
nents. Use only Mopar
not use automatic transmission fluid. Do not over-
fill.
Wipe filler cap clean, then check the fluid level.
The dipstick should indicate FULL COLD when the
fluid is at normal temperature of approximately 21°C
to 27°C (70°F to 80°F).
(1) Fill the pump fluid reservoir to the proper level
and let the fluid settle for at least two (2) minutes.
(2) Start the engine and let run for a few seconds.
Then turn the engine off.
(3) Add fluid if necessary. Repeat the above proce-
dure until the fluid level remains constant after run-
ning the engine.
(4) Raise the front wheels off the ground.
(5) Start the engine. Slowly turn the steering
wheel right and left, lightly contacting the wheel
stops.
(6) Add power steering fluid if necessary.
(7) Lower the vehicle and turn the steering wheel
slowly from lock to lock.
(8) Stop the engine. Check the fluid level and refill
as required.
(9) If the fluid is extremely foamy, allow the vehi-
cle to stand a few minutes and repeat the above pro-
cedure.
POWER STEERING PUMP FLOW CONTROL VALVE
O-RING SEAL
DISASSEMBLE
The power steering pump does not require removal
from the engine for removal and replacement of the
flow control valve fitting O-Ring.
(1) Remove the power steering fluid pressure hose
from power steering pump pressure fitting (Fig. 5).
(2) Remove the power steering pump discharge/
flow control valve fitting (Fig. 6) from the power
steering pump housing. Use care to prevent the
flow control valve and the spring from sliding
out of the discharge/flow control valve fitting.
(3) Remove and discard O-ring seal from fitting.
Power Steering Fluid. Do
FLOW CONTROL VALVE FIT- POWER STEERING PRES- POWER POWER STEERING PRES- ABS HYDRAULIC CONTROL FLOW CONTROL VALVE FIT- POWER POWER STEERING PUMP UNIT HEAT SHIELD STEERING STEERING BANJO FITTING SUPPLY HOSE SURE HOSE SURE HOSE HOUSING FLUID PUMP TING TING
Fig. 5 Power Steering Pump Pressure Hose
Fig. 6 Pump Discharge And Flow Control Valve
ASSEMBLE
(1) If necessary, clean and install flow control
valve and spring in pump housing bore.
(2) Install new O-ring seal on fitting.
(3) Install the discharge/flow control valve fitting
(Fig. 6) into the power steering pump. Tighten the
discharge/flow control valve to a torque of 75 N·m (55
ft. lbs.)
(4) Install power steering fluid pressure hose on
flow control valve fitting (Fig. 5). Tighten the banjo
bolt to a torque of 34 N·m (25 ft. lbs.).
POWER STEERING PUMP SUCTION PORT FITTING
The power steering pump will require removal
from the engine for removal and replacement of the
suction port O-Ring seal. Refer to Power Steering
Pump Service in this group of the service manual for
the required removal and replacement procedure for
the power steering pump.
STEERING
Fitting
19 - 11