E3M111 Line Module "Analogplus" (Supersedes E3M110) - Siemens Cerberus CS1140 Manual

24 E3M111 Line module "AnalogPLUS"
24.1 Overview
24.2 Key data
24.3 Special functions
Building Technologies
Fire Safety & Security Products
Line module for AnalogPLUS detectors
I-Bus module with line processor and independent emergency operation proces-
sor
Designed 4 four loop lines or stub lines
Line inputs protected against over voltage
Card format 100 mm x 200 mm
I-Bus address is set at programming switch "S3"
Addresses per line
Number of wires
Twisted cable
Line resistance
Line capacitance
Short-circuit proof line
Quiescent current at 24 V
Current at supply output
1) Limitations –> see document 001508
Terminal block X10 (20 terminals)
– mounted on module chassis
for the connection of the prefabricated cable to connection level, or
–
for direct connection of the periphery
–
Card chassis
mounted on module chassis
–
Line separator
Upon short circuit the part of the line which malfunctions must be separated from
the rest of the line. This is carried out by line separators integrated in each detec-
tor, manual call point and input/output module. According to EN54, a "simple error"
may not cause the malfunction of more than 32 detectors. After the short circuit the
line automatically reverts to "Normal operating condition".

E3M111 Line module "AnalogPLUS" (supersedes E3M110)

...128 1)
2
recommended
...150 Ω with 128 detectors 1)
...300 nF 1)
yes (autom. detectors, manual call points, input/output modules
with line separator)
210 mA with 512 detectors
(50 mA without detectors + 0.31 mA per D–Bus user)
....500 mA / 18...30 VDC (not stabilized)
(supersedes E3M110)
001260_k_en_--.doc
101
02.2005