Siemens Cerberus CS1140 Manual page 130

E3L020 Control module "I/O"
130
Building Technologies
Fire Safety & Security Products
Legend:
1 Fuses: "F18" 1.25 A/F (monitored) Fuse with high breaking capacity (sand-
filled)
2 Programming switch "S3": "I-Bus address" setting
Each element (module) connected to I-Bus must have an individual address (number).
This is set on programming switch "S3".
Maximum 16 I-Bus devices.
Function / I-Bus address
Nr.
0 Module out of commission (unused)
1 I-Bus user number 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
"S3-1...6" are set to "off" at the factory
3 Flat cable header "ST1" (26-pin): I-Bus
4 Maintenance switch "S2": Test LEDs H1...H16 Switch on / off. To switch on
maintenance LEDs for test purposes. In addition to driver output, enables the
corresponding LED (H1...H16) to be activated. S2-on = LED (H1... H16)
lights if output is activated.
5 Plug-in terminals "K1": Supply to the "I-Bus" modules
6 Fuse: "F19" 1.6 A/F Module supply (SMD fuse can only be changed at fac-
tory)
7 Fuse: "F1" 0.5 A/T (monitored) Fuse with high breaking capacity (sand-filled)
8 Fuses: "F2...F17"
(can only be changed at factory)
9 Test LEDs "H1...H16" at rear. Allocation of LED see chapter 31.4
S3-1 S3-2
off
on
2 off
3 on
4 off
5 on
6 off
7 on
8 off
9 on
10 off
11 on
12 off
13 on
14 off
15 on
16 off
1 A/F inputs/outputs 1....16 (not monitored) SMD fuses
Programming switch S3
S3-3 S3-4 S3-5
off off off off
off off off off
on off off off
on off off off
off on off off
off on off off
on on off off
on on off off
off off on off
off off on off
on off on off
on off on off
off on on off
off on on off
on on on off
on on on off
off off off on
001260_k_en_--.doc
S3-6
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
02.2005