Verification Description - Keysight N6705 Service Manual

2 Performance Verification

Verification Description

Verification and Calibration Equipment Required
Type
Digital Multimeter Resolution: 10 nV @ 1V;
Current Monitor
Load Resistors
Electronic Load
Keysight N6784A
GPIB Controller
Oscilloscope
RMS Voltmeter
Differential
Amplifier
Terminations
Variable voltage
transformer or
AC source
RC – for N678xA
transient test
10
The equipment listed in the following table, or the equivalent to this
equipment, is required for the performance tests and for calibration. Test
record sheets are included at the back of this section.
Specifications
Readout: 8 1/2 digits
Accuracy: 20 ppm
15 A (0.1 ohm), TC = 4ppm/°C
30 A (0.1 ohm), TC = 4ppm/°C
50 A (0.05 ohm), TC = 4ppm/°C
25 Ω, 250 W, 1% (calibration, N6751A/52A; N6761A/62A)
4 Ω, 250 W, 1% (calibration, N6751A/52A; N6761A/62A)
20 kΩ, 1%, 1/8W (verification, calibration for 1UA/2UA)
10 Ω, 1%, 1/8W (verification, calibration for N678xA SMU)
10 kΩ, 1%, 1/8W (verification, calibration for N678xA SMU)
1 MΩ, 1%, 1/8W (verification, calibration for N678xA SMU)
150 V, 50 A minimum, with transient capability and a slew rate
of 833 kA/s or better.
Load for N678xA SMU and N6783A (set to CC load mode)
Full GPIB capabilities
Sensitivity: 1 mV;
Bandwidth Limit: 20 MHz
Probe: 1:1 with RF tip
True RMS;
Bandwidth: 20 MHz
Sensitivity: 100 µV
Bandwidth: 20 MHz
1 – 50 Ω BNC termination
2 – 50 Ω, 1/8 W termination resistors
Adjustable to highest rated input voltage range.
Power: 500 VA
Capacitor: 150 μF fixed film
Resistor 50 mΩ
Recommended Model
Keysight 3458A or equivalent
Guildline 9230A-15R
Guildline 9230A-30
Guildline 9230A-50
Vishay NH-250-25Ω-1%
Vishay NH-250-4Ω-1%
Keysight N3300A mainframe,
with N330xA modules
Keysight N6784A
Keysight 82350B or
equivalent
Keysight Infiniium/6054A or
equivalent
Rhode and Schwartz Model
URE3 or equivalent
LeCroy 1855A or equivalent
Keysight 6813B or equivalent
EPCOS B32526R0157K
Vishay LVR01R0500FE70
Model N6705 Service Guide