Keysight N6705 Service Manual page 64

3 Calibration
64
Step 4. Select the second voltage calibration point.
Front Panel:
The second calibration point is automatically
selected. "Enter P2 measured data" should
be displayed.
Step 5. Measure the output voltage with the DMM and enter the data.
Front Panel:
Enter the value from the external DMM into
the data field and then select Next. If
calibration is complete, select Close.
Step 6 only applies to models N6781A and N6782A.
Step 6. Repeat steps 1 through 5 for the 600 mV range.
Steps 7 through 9 only apply to model N6784A.
Step 7. Select the third voltage calibration point for the negative range.
Front Panel:
The third calibration point is automatically
selected. "Enter P3 measured data" should
be displayed.
Step 8. Measure the output voltage with the DMM and enter the data. The value
should be negative.
Front Panel:
Enter the value from the external DMM into
the data field and then select Next. When
calibration is complete, select Close
Step 9. Repeat steps 1 through 5, 7 and 8 for the 600 mV range.
Low Range Voltage Measurement - Models N6781A, N6782A,
N6784A
Step 1. Select the low-voltage measurement range. The value entered must be
the maximum voltage of the range to be calibrated. This example selects
the 1 V range of output 1.
Front Panel:
From the Calibration menu, select
Voltage, Low Range Measurement. Then
select Start.
Step 2. Select the first voltage calibration point.
SCPI Command:
CAL:LEV P2
*OPC?
SCPI Command:
CAL:DATA <data>
SCPI Command:
CAL:LEV P3
*OPC?
SCPI Command:
CAL:DATA <data>
SCPI Command:
CAL:VOLT:MEAS 1
, (@1)
Model N6705 Service Guide