Keysight N6705 Service Manual page 95

Disassembly 4
Removing/Installing the Top Backplane PCA
Step 1. Remove the top chassis as previously described.
Step 2. Remove three screws using a T10 driver from the chassis on the
side opposite to the backplane PCA.
Figure 4-23
Step 3. Disconnect any remaining cables if required, and either cut or
carefully slide the two push-on retainers off of the retaining pins.
Figure 4-24
Step 4. Remove the top backplane PCA.
Step 5. To install the top backplane PCA, perform steps 1-4 in reverse
order. New push-on retainers can be purchased separately.
Model N6705 Service Guide 95