Keysight N6705 Service Manual page 70

3 Calibration
70
Front Panel:
The second calibration point is automatically
selected. "Enter P2 measured data" should be
displayed.
Step 6. Measure the current with the Keysight 3458A and enter the value.
Front Panel:
Enter the value from the external DMM into
the data field and then select Next.
Step 7. Select the third current calibration point for the negative range.
Front Panel:
The third calibration point is automatically
selected. "Enter P3 measured data" should be
displayed.
Step 8. Measure the current with the Keysight 3458A and enter the value. This
value should be negative.
Front Panel:
Enter the value from the external DMM into
the data field and then select Next. When
calibration is complete, select Close.
Step 9. Repeat steps 1 through 8 for the 10 mA programming range of model
N6784A.
100 mA Measurement Range - All Models
Step 1. Connect only the current measurement terminals of the Keysight 3458A
to the output terminals (see Cal Setup D without the resistor).
Step 2. Select the 100 mA range of output 1.
Front Panel:
From the Calibration menu, select
Current, 100 mA Measurement
Range. Then select Start.
Step 3. Select the first current calibration point.
Front Panel:
The first calibration point is automatically
selected. "Enter P1 measured data" should be
displayed.
Step 4. Measure the current with the Keysight 3458A and enter the value.
SCPI Command:
CAL:LEV P2
*OPC?
SCPI Command:
CAL:DATA <data>
SCPI Command:
CAL:LEV P3
*OPC?
SCPI Command:
CAL:DATA <data>
SCPI Command:
CAL:CURR:MEAS 0.1
, (@1)
SCPI Command:
CAL:LEV P1
*OPC?
Model N6705 Service Guide