Keysight N6705 Service Manual page 84

4 Disassembly
NOTE
Removing/Installing Flat Flexible Cables (FFC)
84
Step 4. Connect the output cables.
Push the harness connector into the power module. Use the correct size
connector and channel for the power module (see Figure 4-2 for channel
locations).
Tighten the locking screws on the small connectors.
Secure the unused cables in the plastic clip ring located between the
modules and the front panel.
+S + -S
Figure 4-3
For double-wide power modules, connect the output 1 cable in the top
chassis; connect the output 3 cable in the bottom chassis.
Step 5. Install the top and bottom covers.
Slide the top (or bottom) cover into place and tighten the thumbscrews.
Note the position of the conductive side of the FFC cable for re-
installation. The blue tab is on the non-conductive side of the cable.
To remove the FFC cable, gently lift up on the tabs located on the short
ends of the plastic connector until the cable is released. Remove the
cable.
To install the FFC cable, insert the cable into the slot in the connector.
Using a small screwdriver or your fingers, apply gentle, even pressure to
the tabs until the connector clicks and locks the cable into place. After
installation, check the cable to ensure the cable is straight and securely
aligned within the connector.
Figure 4-4
Model N6705 Service Guide